Step #1: Nail Preparation

1. Sanitise your hands and request the clients to sanitise their hands.
2. Ensure the tools are sterlised.
3. Use the cuticle pusher to push back the cuticles.
4. Use E-File for the next step, check the E-File Application guide.
5. Trim the extra cuticles with the nippers.
6. File nails into the desired shape using a 180/240 grit nail File.
7. Gently buff the nails with the Buffer to remove any shine.
8. Dehydrate and cleanse the nail plate using pure acetone.

Step #2: Base Coat

1. Apply a thin layer of Rubber Base Coat and seal the free edge.
2. Cure it with the LED lamp for 90 seconds.
   (Note: If the client experience any ‘heat-spike’, politely ask them to take their hands off from the lamp for a second and then put them back).

Step #3: First Layer

1. Apply a first thin layer of the gel colour (specified by client) and make sure to seal the free edge. Use a liner brush to perfect the cuticle and side walls if necessary.
2. Cure it for 90 seconds in the LED lamp.

Step #4: Second Layer

1. Follow the same step as the First Layer.
   (Note: Discuss with the client and apply the third layer if required.)

Step #5: Top Coat

1. Apply the Extreme Shine Top Coat or Matte Top Coat based on the client’s preference, and seal the free edge.
2. Cure it using the LED lamp for 90 seconds. No need to wipe or cleanse after curing.
   (Note: All top coats are non-wipe.)
3. Apply a small amount of cuticle essence/oil to the cuticle area to moisturise them.